Dongguan Wiiki-tech Electronic Co., Ltd

Model Number: AUX-Ford-1 Brand Name: Wiiki-Tech Key Specifications/Special Features: Vehicle applications:FORDEdge 2007-2010Expedition 2007-2009Explorer 2006-2009

F-150 2004-2008

F-250 2005-2009

F-350 2005-2009

F-550 2005-2009

Focus 2005-2007

Freestyle 2005-2007

Fusion 2006-2009

Mustang 2005-2009

Sport Trac 2007-2009

LINCOLN

Mark LT 2006-2008

MKX 2007-2009

Navigator 2007-2009

Zephyr 2006

Mercury

Milan 2006-2009

Mountaineer 2006-2009

Installation instructions:

• Disconnect the negative battery terminal
• Remove the Ford radio to gain access to the connectors on the back of the radio
• Remove any connector that may be in the 16-pin data port
• Plug the 16-pin connector of the AAI-FD4 into the 16-pin Data port of the Ford radio
• Reconnect the factory 16-pin data cable (if present) into the mating socket on the AAI-FD4 (see note on back)
• Connect back/green wire of AAI-FD4 to ground (vehicle chassis)
• Connect gray/violet wire of the AAI-FD4 to a constant +12 volt source
• Connect appropriate length patch cord (not included) between the AAI-FD4 and auxiliary device
• Rotate the input sensitivity adjustment pot of the AAI-FD4 to its full clockwise position (minimum level)
• Re-install factory radio
• Reconnect the negative battery terminal

Install it right with AAI-FD4:

• Do not force connectors together as pin damage may occur
• This installation will be flawless if you take your time making the connections described below
• Following the installation sequence below is critical to ensure proper recognition of the auxiliary device by the factory radio

General overview:

• AAI-FD4 converts the rear seat entertainment port of specified OEM Ford/Lincoln/mercury can-bus radios to RCA level audio
• Input: AAI-FD4 features built-in audio adjustment circuitry with a 0 to +20 dB input sensitivity range of 0.475 to 4.75 volts (peak to peak)
• Allowing the installer to match the audio level of the AUX device to the audio level of the AM, FM, or CD modes of the factory radio

Verify operations:

• With radio on, activate auxiliary device
• Set volume on auxiliary device to preferred listening level
• Push the aux button on radio to gain access to auxiliary audio input
• Display on radio will show DVD/CD for a few seconds, then will display PAC HI-FI
• Verify that audio of auxiliary device is heard
• Rotate the input sensitivity adjustment pot of the AAI-FD4 counter-clockwise until volume level of auxiliary device matches that of AM, FM, or CD modes